Jenly Wholesale Inc Party Supplies, 15420 SW 136th St, #19, Miami, FL33196

news

How to make a Jordan Almond Flower Favor

jenly favors

How to make a Jordan Almond Flower Favor

Supplies:

Supplies

Directions:

1.Pull and open the Flower Petal Almond Holder Ribbon and place one almond on each pedal for a total of five pedals.

2.     Firmly grasp the string and pull the string tight on the Flower Petal Almond Holder Ribbon to form a five petal flower.

3.      Cut the fifth petal from the ribbon and tie off the two white string (one from each end) to hold the flower in place.

4.     Next take the roll of Ivory 1 1/2" Organza Capia Pull Bow Ribbon, firmly grasp the string and pull the string tight (about 12" inches of ribbon) to form a circular pattern flower.  Tie off the two white string (one from each end) to hold the bow in place.

5.     Now place the Flower Petal Almond Holder Ribbon on a flat surface.  Warm up the glue gun. Squeezed a small dab of glue to the center of the Flower Petal Almond Holder Ribbon and place the Ivory 1 1/2" Organza Capia Pull Bow Ribbon on top of the Flower Petal Almond Holder Ribbon.  Try to center the two flowers.  Press surfaces together within 15 seconds. CAUTION: Hot melt glue gets hot!

6.     Take the Personalized ribbon and form a small loop at the top.  Again Squeezed a small dab of glue where the ribbon meets and press surfaces together within 15 seconds. CAUTION: Hot melt glue gets hot!

7.Now take the two flowers that you previous glued together Squeezed a small dab of glue to the center of the top flower (Ivory 1 1/2" Organza Capia Pull Bow Ribbon), then place the Personalized ribbon on top of the top flower and press surfaces together within 15 seconds. Remember to center the personalized ribbon.CAUTION: Hot melt glue gets hot!

8.     Grab the package of Ivory Organza & Satin Rose Bud With Pearl and cut off one of the flowers (but be sure to leave about ¼” inch of stem).  Fold the stem back against the flower to make it flush with the flower.  Again grab the glue gun and place a small dab of glue on the back of the flower.  Place the flower in the middle of the personalized ribbon and press surfaces together within 15 seconds. CAUTION: Hot melt glue gets hot!

 

Congratulation! Your elegant and unique Jordan Almond Flower Favor is done!

 

 


Older Post Newer Post


Leave a Comment

Liquid error: Could not find asset snippets/findify-tagging.liquid